DAB/DAB+

General Description

The MW_DAB modulator core performs the digital baseband function for the transmission side of new generation Digital Audio Broadcasting. The MW_DAB core is designed to achieve high performance for a single chip FPGA based design, including control and status management. The modulator core is configurable to supports all several TX modes, 1/2/3/4. It receives as input the MPEG II audio signal and other data, as the information relating to FIB and Channel, and implements the modules to build the DAB modulated signal. Each service is individually coded at source level in the modulator, with error protection and time interleaving. The services are multiplexed in the Main Service Channel (MSC), and finally, Orthogonal Frequency Division Multiplexing (OFDM) is applied to the stream. Internal 20-bit architecture for high level MER and BER performances is provided.       The core is implemented to accept up to 16 channels as inputs. A larger capability could be obtained using additional FPGA resources. FPGA netlist only or complete design environment package are deliverable. The core was developed in Vivado tool, written in HDL code.

Features

• Fully compliant with ETSI EN 300 401 V1.4.1 2006-06, for DAB
• DAB-Modes: I, II, III, IV
• All protection levels supported
• Synchronous design
• Supported channels up to 16
• Max delay < 100 ms, and depending on used DAB-Mode
• Frequency range : VHF (III) 170 MHz to 254 MHz,   L band, with occupied bandwidth 1.536 MHz
• Network type: SFN
• Reference Standard : ITU-T G703-G704, EN 300401, EN 300799, EN 302077-2
• DAB Input Signal : ETI (NI) 2.048 MHz or ETI (NA)
• Typical MER > 40 dB at overall frequency range
• Optional Features:
  • Digital linear adaptive pre-correction
  • Digital nonlinear adaptive pre-correction

Typical Application